Quistgaard’s Copper: Mid-Century Modern Cookware for Dansk

I recently acquired the entire line of copper cookware designed by Jens Quistgaard for Dansk. It appears never to have been used.

Quistgaards Copper.jpg

Pots and pans were an early design concern of Quistgaard.  Though he had been designing objects in the 1940s, by the mid 1950s Quistgaard found success with his creation the Anker Line of enameled cast-iron cookware produced by De Forenede Jernstoberier.  Shortly after joining Dansk, Quistgaard designed his Kobenstyle  cookware, a much more lightweight metal enameled in primary colors. 

Pages from a pamphlet for Anker Line (which also featured removable handles), and examples of Kobenstyle, both designed by Quistgaard.

Pages from a pamphlet for Anker Line (which also featured removable handles), and examples of Kobenstyle, both designed by Quistgaard.

In the productive years around 1960, when Dansk released numerous new lines including Rare Woods, Festivaal, Cane and Teak, and several new flatware patterns, Quistgaard developed the line of cookware that would bear his name:  Quistgaard’s Copper.   

Page from an undated Dansk catagloue, circa 1960.

Page from an undated Dansk catagloue, circa 1960.

7-, 4-, and 2-quart copper casseroles.

7-, 4-, and 2-quart copper casseroles.

All three of the taller casseroles came with porcelain liners.

All three of the taller casseroles came with porcelain liners.

3.5-, 2-, and 1-quart copper saucepans

3.5-, 2-, and 1-quart copper saucepans

Only the largest of the saucepans (3.5-quart) has a porcelain liner.

Only the largest of the saucepans (3.5-quart) has a porcelain liner.

Traditional copper pots. The pot on the left is by Dehillerin of Paris, the firm favored by Julia Child. Via Food 52.

Traditional copper pots. The pot on the left is by Dehillerin of Paris, the firm favored by Julia Child. Via Food 52.

Copper pots for cooking and other household uses have been made for millennia.  Copper heats quickly, disperses heat evenly, and cools off quickly, all of which makes for good control when cooking.  Ingesting copper is not good, so most pots are lined with another material.  Dansk copper is lined with tin, often used because it will not react with acids and is fairly non-stick; tin, though is soft and has a low melting point, so it is prone to wear if not handled properly.  

_MG_1900.jpg
The rivets are polished flush with the handles.

The rivets are polished flush with the handles.

Quistgaard’s copper came in taller casseroles and shorter saucepans. The pots, made in Portugal, were copper lined with tin, with brass handles. He kept the main elements of traditional copper pots and simplified the lines of the handles and eliminated the obvious connectors.  The pots were touted as ‘casserole, kettle, double boiler, wine cooler, chafing dish, one at a time or all in one.’ Lids, porcelain liners, and teak handles were all sold separately.  

Three sizes of removable teak handles, made in Denmark. The wheel at the top of the handle releases the internal hook. The wheel can be very difficult to turn.

Three sizes of removable teak handles, made in Denmark. The wheel at the top of the handle releases the internal hook. The wheel can be very difficult to turn.

From an undated Dansk price list, circa 1960.

From an undated Dansk price list, circa 1960.

Quistgaard’s copper was expensive as compared to other pieces produced for Dansk.  The largest copper pot (7 quarts) with the lid, porcelain liner, and wood handle cost $52.85, whereas the largest Kobenstyle piece, the 6-quart casserole, was only $16.95.  A five-piece place setting of the sterling silver Tjorn flatware was $49.95, the same price at which the largest pieces from the Rare Woods line topped out.  The chafing dish (which was apparently never illustrated in catalogues) was the most expensive single item in the line, at $69.80.  

Brass and teak chafing dish, model 1310CH. This piece was shown in Dansk advertisements as early as 1956, before the copper line was introduced.  Photo via Invaluable.

Brass and teak chafing dish, model 1310CH. This piece was shown in Dansk advertisements as early as 1956, before the copper line was introduced. Photo via Invaluable.

_MG_1906.jpg
Brass burner and stand. The teak on the underside of the stand has the usual Dansk mark for this period and the brass cross piece is also marked.

Brass burner and stand. The teak on the underside of the stand has the usual Dansk mark for this period and the brass cross piece is also marked.

Dansk advertisement with Bert Stern photo featuring the 7-quart casserole on the burner and stand, 1960.

Dansk advertisement with Bert Stern photo featuring the 7-quart casserole on the burner and stand, 1960.

The copper line was featured in Dansk advertisements in 1960 and 1961, the former of which was photographed by fashion photographer Bert Stern.  Stern, known for many iconic images from the 1960s including the the last photo shoot of Marilyn Monroe before her death, shot for Dansk from 1957 until at least 1960.  

Manufacturer’s care card, which notes the need to remove the lacquered finish on the pots before use.

Manufacturer’s care card, which notes the need to remove the lacquered finish on the pots before use.

Mimeographed (or ditto?) memo from Dansk about caring for the pots.

Mimeographed (or ditto?) memo from Dansk about caring for the pots.

Whether due to low demand or high production costs, Quistgaard’s copper only seems to have been made for a very short time in the early 1960s.  The less expensive Kobenstyle line, however, continued for many years (and was recently reproduced), and Quistgaard went on to design another line of enameled cast-iron cookware around 1970. 

The underside of some—but not all—brass handles were marked with the Dansk four ducks mark; some also had a foil label on the underside of the pot.

The underside of some—but not all—brass handles were marked with the Dansk four ducks mark; some also had a foil label on the underside of the pot.

This lid is from a different set of pots and shows that the inner rim of some lids were stamped with the Dansk mark.

This lid is from a different set of pots and shows that the inner rim of some lids were stamped with the Dansk mark.

The Dansk mark was also included on the underside of the porcelain liners (though I have seen liners that are unmarked).

The Dansk mark was also included on the underside of the porcelain liners (though I have seen liners that are unmarked).

I have found additional unused copper pots in this pattern that were not marked on the handles (but had the Dansk label on the underside), and confusingly, included both the ‘Hand Crafted Copper’ insert seen above and a care card insert that gave the company name as Dansk Designs International, which was used in the 1970s. During that decade (or maybe the 1980s?), Dansk did produce another line of copper pots that were made in Norway. I can’t imagine the two designs were sold at the same time? Definitely an area for more research…

Dansk Fjord and Kongo Flatware Price Lists and Care Card, 1960 and circa 1964

Primary documentation is always useful when trying to figure out 20th century design.  I find it terrifically frustrating that a vast amount of printed information was produced but relatively little of it seems to be available for reference.  If I have it, I will share it!

Above is a price list for Dansk's Fjord line of flatware, conveniently dated March 1960 (you can read my post on Fjord here).

Interesting that the prices are given in Danish kroner--Dansk was an American company and the flatware was made in Germany, but giving the price in a foreign currency certainly stressed the connection with popular Danish design.  At that time, the exchange rate was 6.89 kroner to the dollar, so the dinner knife listed would have been about $2.28. 

The second price list is not dated, but presumably a few years later (circa 1964?) as the price has gone up by nearly 30%.  Also curious (to me, at least) that the teak-handled Fjord and the nylon-handled Kongo were the same price.  I would have guessed that the plastic Kongo would have been less expensive than Fjord, with the imported teak handles.

I also have this hang tag for Fjord, which gives care instructions for the flatware.  Basically, don't put it in a dishwasher or let it soak in water and give it a little oil treatment now and then.  I use my Fjord every day!

I usually have some Fjord flatware and other Dansk pieces in my shop (check out that section of my website) and I am always looking for more to buy. 

Dansk Teak Condiment Box - Acorn Jar by Jens Quistgaard, early 1960s

I recently found a Dansk condiment box, popularly called an 'acorn jar' because of its shape.  It's a sweet little thing, and pretty hard to find in comparison to many Quistgaard designs.  Unlike most Dansk pieces, which are staved, this one is small enough to be turned from a single piece of teak for both the lid and container.

This piece is listed as model 807 in a Dansk catalogue from the early 1960s and sold for $10.95.

I'm not exactly sure what condiment would have been used in this little box--sugar, maybe?  Weird to call sugar a 'condiment'.  If you have thoughts on the matter, let me know! 

If you'd like to see the Dansk pieces I have for sale in my Etsy shop, click here.   I'm always looking to buy collections or single pieces of early Dansk! 


Dansk Teak Ice Buckets as Modern, Stackable Storage

I started buying Dansk ice buckets and once I got a couple, I realized how nicely they stack together.   They're all the same diameter and the lid of the one in the foreground fits right into the recessed underside of each design.  These all date from the late 1950s to the mid '60s. 
Each bucket is lined with black plastic and Dansk touted them as good for insulating both  ice and hot hors d'oeuvres.  If I actually had furniture, I would make stacks of these on top of a sideboard, or set into bookcases.

My living room is starting to look like I felled a teak forest, so I will list these in my shop  here.


© All text and images are copyright of Jeni Sandberg